Home > Radiant Heating Systems > Heating Control Panels > Manifold Panels
This is simplest panel to install with the manifold installed on the heating control panel. Simply connect your pex lines to the manifold on the panel using the provided pex adapters, then connect your boiler supply/return to the panel supply/return ports.

This panel is designed for one-level radiant system where all pex loops are located in the same area. The Manifold panel can be designed as a one heating zone system or a multiple-zone system depending upon your requirements. Choose your design based on the location of your boiler relative to the panel (right or left of the panel), the fuel/heat source you are planning on using and whether you will have more than one zone. After selecting the design below, you will be able to choose your the manifold size and number of heating zones you have.
Sort By:
Page of 1
radiant heating control panel Single Zone (2-12 loop) Manifold Heating Control Panel

Interfaces with combination boiler or boiler with internal pump.

Our price: $2,800.00 *Price listed for 2 loop manifold , click on product to build your custom price
radiant heating control panel Multiple Zone (4-12 loop) Manifold Heating Control Panel

Interfaces with combination boiler or boiler with internal pump.

Our price: $3,200.00 *Price listed for 4 loop manifold , click on product to build your custom price
   
 
Panel features:
  • Primary/secondary loop design for the highest efficiency and boiler protection.
  • Delta-T pumps for high efficiency, economy and comfort not possible with single or three-speed pumps. The standard pump includes a display showing watts, GPM and supply and return temperatures.
  • Most panels use a single pump with multiple zone valves or actuators for weight and cost savings while adding durability and longevity. (A second pump from the boiler to the panel may be needed for heat sources that do not have their own built-in pump.)
  • Boiler interface with union ball valves for easy connection.
  • Expansion tank mounted upright and connected by a union ball valve for easy isolation and removal for servicing.
  • Glycol-rated bladder expansion tank (membrane never touches the inside of the tank).
  • Unique bypass valve that allows isolation of onboard manifold, remote manifold(s), boiler and panel for easier purge and fill.
  • Fill ports to fill entire system—including boiler—from a single location.
  • Cabinet-grade wood panel backing to allow sizing to minimal size possible and easy mounting.
  • Aluminum wall mounts for strength and aesthetics.
  • Clearly labeled components, flow directions and instructions right on the panel.
  • All on-board components pre-wired.
  • Installation guide with photos, examples and tips.
  • Copper ProPress fittings for a compact, clean design.
  • Components that match for a pleasing look.